Quantcast
Channel: Automotive Repair Manual Download and Reviews » Search Results » 2005 chevy silverado ground wire location
Viewing all articles
Browse latest Browse all 10

Honda Civic Remote Starter Installation Instructions

0
0

A remote starter is a device that permits a driver to begin the car from a remote location, comparable to the within of a house or office. The main advantages of a remote starter are to permit a automobile to warm up previous to being pushed and to run the heat or air conditioner so as to establish an ambient inner temperature earlier than the driver enters. Some newer cars have manufacturing facility-put in remoter starters, but in case you personal a Honda Civic you’ll have to set up an after-market remote starter.

Honda Civic Remote Starter Installation Instructions

1. Open the Civic’s hood and disconnect the vehicle’s battery. Guantee that the automobile is turned off before doing this.
2. Take away the warmth cover beneath the driving force’s side dashboard by pulling out the 4 pins holding the cover in place. Use the needle nostril pliers to take away the pins.
3. Affix the remote starter on the plastic molding on the internal left of the heat vent utilizing a skinny coat of rubber cement.
4. Bolt the hood pin from the remote starter package to the plastic clamp near the Civic’s hood latch. Use the 6-inch metal bolts and the adjustable wrench to safe the hood pin in place.
5. Unwind the wire hanger and connect some electrical tape to the end. Use the hanger to push the gray wire (the ability wire) from the starter by means of the warmth duct and into the engine area of the Civic.
6. Pull the grey wire across the engine, routing it along the automobile’s current wire harness situated on the motive force’s facet of the hood. Fasten the grey wire to the hood pin by crimping the ends of the wire across the hood pin with your hands. If necessary, secure the wire to the hood pin with a small amount of electrical tape.
7. Feed the red wire (the ignition wire) from the starter as much as the automobile’s ignition harness. On a Honda Civic, the ignition harness is situated behind the steering column. Solder the top of the purple wire to the gauge wire in the midst of the ignition harness and wrap the connection area in electrical tape.
8. Thread the remote starter’s floor wire through the heat duct and secure it to a ground (corresponding to a metallic object) beneath the Civic’s hood. Wrap the ends of the ground wire across the ground and crimp firmly with your hands.
9. Mount the starter antenna on the highest of the driving force’s facet dashboard with the rubber cement. Run the wire from the antenna underneath the dashboard to the remote starter mounted in the warmth duct. Plug the antenna wire into the remote starter.
10. Reconnect the Civic’s battery and make sure the automotive’s lights and electrical system are functioning properly. Take a look at the remote starter to make sure that it works.


Viewing all articles
Browse latest Browse all 10

Latest Images

Trending Articles





Latest Images